Table of Contents
Advertisement
Installation
After unpacking the oven, make sure that it has not
been damaged during transit and that the oven
door closes properly.
In the event of problems, contact the dealer or
your nearest After-Sales Service. To avoid any
damage, only remove the oven from its
polystyrene foam base at the time of installation.
Preparing the housing unit
• Kitchen units in contact with the oven must be
heat resistant (min 90°C).
• Carry out all cabinet cutting work before fitting
the oven in the housing and carefully remove all
wood chips and sawdust.
• After installation, the bottom of the oven must
no longer be accessible.
• For correct appliance operation, do not
obstruct the minimum gap between the
worktop and the upper edge of the oven.
Electrical connection
Make sure the power voltage specified on the
appliance dataplate is the same as the mains
voltage. The dataplate is on the front edge of the
oven (visible when the door is open).
• Power cable replacement (type H05 RR-F 3 x
1.5 mm
2
) must be carried out by a qualified
electrician. Contact an authorized service
centre.
GENERAL RECOMMENDATIONS
Before use:
• Remove cardboard protection pieces,
protective film and adhesive labels from the
oven and the accessories.
• Remove the accessories from the oven and heat
it at 200°C for about an hour to eliminate the
smell and fumes from the protective grease and
insulating materials.
During use:
• Do not place heavy objects on the door as they
could damage it.
• Do not cling to the door or hang anything from
the handle.
• Do not cover the inside of the oven with
aluminium foil.
• Do not pour water into the inside of a hot oven;
this could damage the enamel coating.
• Do not drag pots or pans across the bottom of
the oven as this could damage the enamel
coating.
• Make sure that the electrical cables of other
appliances do not touch hot parts of the oven
or become trapped in the door.
• Do not expose the oven to atmospheric agents.
8
Advertisement
Table of Contents
