Advertisement
Inside of cart, insert rear shield tab into left slot on upper of lower back panel. Insert left and right grease tray rails into slots
beneath grease tray opening in upper back panel, shown A. Attach front shield tabs under front brace and attach right and
left rails under front brace with three #8x3/8" self-tapping screws, shown B.
Grease trayopening
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right
side panel with the nut, shown A.
Insert AA battery intoignition module, negative (-) end first. Then put on the cap, shown B.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the electronic ignition
module. Total (5) connections. Connect the two wires (A and B) from the switch wiring harness into the back of the electronic
ignition module. Total (2) connections, shown C.
NOTE: Switch terminals are larger than electrode
terminals and should only be installed in
location shown as (A), (B).
19
Advertisement
