Advertisement
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 114-20x11/2 '' screws, 7ram lock washers, and 7ram flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART,
Note:someparts omitted
for clarity of illustration
7ram fiat
7ram lock
114-20×1V2"
washer
washer
screw
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8" screws and 4ram lock washers. Press sideburner control knob onto valve stem.
Note: Use left and right
Note: Use upper and lower
holes on fascia to
holes on lasc=a to
attach valve bracket
Screws and Washers
attach bezel
removed from valve bracket
Control knob
#8-32x318" s crew
Valve stem
Sideburner
valve bracket
Install bezelwith "OFF" at top.
Control knob bezel
4ram
lock washer
17
Advertisement
