Kenmore 385. 16633 Owner's Manual page 2

IMPORTANT SAFETY INSTRUCTIONS
Your overlock machine is designed and constructed only for HOUSEHOLD use
Read al! instructions before using this ovedock machine_
DANGER - To reduce the risk o felectric shock:
1_ An overlock machine should never be left unattended when plugged in.
Always unplug from the electric outlet immediately after using and before cleaning.
2. Always unplug before replacing the bulb Replace bulb with same type rated 15 Watts.
3. Do not reach for the machine if it falls into water. Unplug it immediately.
4 Do not place or store the overlock machine where it can fall or be pulled into a tub or sink. Do not place or drop into
water or other liquid.
WARNING
- To reduce the risk of burns, tire, electric shock, or injury to persons:
1. Do not allow to be used as a toy. Close attention is necessary when this overlock machine is used by or near
children
2. Use this overlock machine only for its intended use as described in this manual
Use only attachments recommended by the manufacturer as contained in this manual
3 Never operate this overlock machine if it has a damaged cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water
Return the overlock machine to the nearest authorized dealer or service center for examination, repair, electrical or
mechanical adjustmenL
4. Never operate the overlock machine with any air opening blocked. Keep ventilation openings of the overlock machine
and foot controller free from accumulation of lint, dust, and loose cloth
5 Never drop or insert any object into any opening
6 Do not use outdoors
7_ Do not operate where aerosol (spray) products are being used or where oxygen is being administered
8 To disconnect, turn all controls to the off position, then remove plug from outlet
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts Special care is required around the needle and knives
11_ Always use the proper needle plate The wrong plate can cause the needle to break
12_ Do not use bent needlesr
13 Do not pull or push fabric while stitching
It may deflect the needle causing it to break_
14_ Switch the machine off when making any adjustment in the needle area, such as threading needle, changing
needle, threading loopers, or changing presser foot, and the like
_5_ Always unplug the overlock machine from the electrical outlet when removing covers, lubricating, or when making any
other user servicing adjustments mentioned in the instruction manual
SAVE THESE INSTRUCTIONS