Sharp MX 4501N - Color Laser - All-in-One Installation Manual page 68

J. Clear the image memory.
1) Switch the operation panel to the copy mode and use the key
operation [P], [ ], [C], and [ ] to enter the simulation mode.
2) Use the numeric keys to enter [66] in the main code entry
screen shown below and press the [START] key.
3) Use the numeric keys to enter [10] in the sub-code entry
screen shown below and press the [START] key.
4) In the submenu screen shown below, press [EXECUTE] on the
touch panel.
After [YES] on the panel lights up, press it.
5) The screen shown below is displayed and memory clear oper-
ation is executed.
6) After several minutes, memory clear operation is completed
and the [YES] button goes out. Press the [CA] key to exit from
the simulation mode.
Then the main unit is automatically rebooted.
K. Connect the line cable to the fax box unit.
Connect the line cable of the line side to the modular jack indicated
with "LINE."
• For using an external telephone:
For using an external telephone, wind the line cable around the
supplied ferrite core by two turns and connect the cable to the
modular jack indicated with "TEL."
MX3500N MX-FXX1 14 – 4