Sharp MX 4501N - Color Laser - All-in-One Installation Manual page 24

3) Remove the screw. Disengage the engagement in the front
side then in the rear side, and remove the paper exit cover.
4
3
4) Connect the connector, and install the exit roller unit (package
part No. 1). Use the screw which was removed in step 3) and
fix the unit.
5) Install the connector cover, and fix it with the screw.
6) Install the exit tray unit (A) and the full detection actuator (B)
(package part No. 2).
* Be careful of the installing direction of the full detection actu-
ator.
B
1
2
B
A
MX3500N MX-TRX2 3 – 2
C. Turn on the power of the main unit.
1) Connect the earth cord, and insert the power plug of the main
unit into the power outlet.
2) Open the front cabinet.
Turn ON the power switch in the front cabinet of the main unit.
3) Turn ON the power switch on the operation panel.
D. Tray setting
Use SIM26-1 to set the tray YES/NO.
ON
ON
ON