Sharp MX 4501N - Color Laser - All-in-One Installation Manual page 35

2. Installation
<Note before installation>
* Before starting installation, check to insure that the data lamp on
the operation panel does not light up or blink.
A. Turn off the power of the main unit
1) Turn OFF the power switch on the operation panel.
2) Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
3) Remove the earth cord and disconnect the power plug of the
main unit from the power outlet.
OFF
OFF
OFF
MX3500N MX-FNX1 5 – 2
B. Removal of the paper holding arm unit
1) Push up the section A to disengage the pawl, and remove the
paper holding arm and the paper holding arm holder together
as a unit.
* Be careful to remove both of the paper holding arm (which is
easily removed alone) and the paper holding arm holder.
2
C. Installation of the inner finisher
1) Open the front cover.
2) Remove two screws, and remove the front cabinet upper.
A