Sharp MX 4501N - Color Laser - All-in-One Installation Manual page 60

: Jul. 15 2006
3
Describes details of the check operations following.
3
1) Enable the document control function.
Touch the [SYSTEM SETTINGS], and touch the [DOCUMENT
CONTROL SETTING]. Set the copy mode to always print,
enable the document control function.
2) Check the document control function.
a) Set the color mode to full color with the initial screen of
copy.
b) Set the pattern print color to the [Y (Yellow)] and [C
(Cyan)], set to the [Bk (Black)] with full color mode, then
copy the blank paper with B/W mode. Use the specified
A4 paper by SHARP, be sure to don't use the back print
paper.
c) Set on the document table the each paper that printed by
procedure b), and copy it.
d) After copy operating, [Detected the document control pat-
tern. Job is aborted.] is displayed on the touch panel. If the
message displayed and no print is made, the operation
check is completed.
If the result executed by each color ([Y (Yellow)] / [C
(Cyan)] / [Bk (Black)]) displays [Detected the document
control pattern. Job is aborted.], the operation check is
normally completed.
e) When print is made at procedure d), check the connection
of the DOCC PWB.
f) After check at the installing, touch the [SYSTEM SET-
TINGS], and touch the [DOCUMENT CONTROL SET-
TING], then set the copy mode to always unprint. (When
case of maintenance, set to the original user setting.)
MX3500N MX-FRX2, MX-FRX2U 9 – 4