Sharp MX 4501N - Color Laser - All-in-One Installation Manual page 47

2) Install the Operation Manual storage cover (which was
removed from the machine) to the saddle finisher.
First, insert the pawl on the lower side of the Operation Manual
pocket.
Then, lift the pawl on the upper side and insert it, and slide
down to install.
2
1
B. Connection of the main unit and saddle
finisher
1) Fix the connection plate (package part No. 2) to the paper feed
desk with two fixing screws A (package part No. 5).
2) Install the rail bracket to the frame with four fixing screws B
(package part No. 6).
C. Staple unit installation
1) Open the front cover of the finisher, and insert the staple unit
(package part No. 3).
2) As shown in the figure, rotate the roller rotation knob so that
the triangle mark is fit with the indication.
1
3) Insert the staple cartridge (package part No. 4) into the staple
section until it clicks.
NOTE:
Check to confirm that there are no clearance at the left and
right sections of the staple cartridge.
4) Insert the staple unit and close the front cover of the finisher.
MX3500N MX-RBX1, MX-FNX2 7 – 5
Roller rotation knob
Staple unit