Features Menu; Feature Descriptions - Avital AviStart 3100 Installation Manual

Hide thumbs Also See for AviStart 3100:
Table of Contents

Advertisement

features menu

The factory default settings are indicated in bold text in the table below.
FEATURE
DEFAULT - LED ON SETTING
NUMBER
(PRESS CHANNEL 1)
1
Engine checking on
2
Tachometer checking type
3
12 minutes run time (1)*
4
Flashing parking light output
5
Cranking time 0.6 sec. (1)
6
High voltage check level
7
Auxiliary output: factory alarm disarm
8
Normal status output
9
Activation pulses: 1 (1)
10
Ignition-controlled locking on
11
Ignition-controlled unlocking on
*NOTE: The numbers in parentheses indicate the number of times the LED will flash

feature descriptions

1 ENGINE CHECK ON/OFF: In the default setting the remote start will monitor either the vehicle's tach wire or
voltage depending on the programming of Feature 2. If programmed off, the vehicle will crank for the pro-
grammed crank time (Feature 5) and will not verify with tach or voltage that the vehicle is running. In the off
setting, if the vehicle fails to start, the ignition can stay on for the entire run duration. Using tach or voltage
check is always recommended if possible.
2 TACH WIRE SENSE/VOLTAGE SENSE: If the tachometer signal wire is used, this feature must be left in the
default (tach wire connected) setting. If programmed to the voltage sense setting, the unit will crank the starter
for a preset time that can be programmed in Feature 5. Once the starter has been engaged, the system will check
the voltage level to verify the engine is running. The threshold for the voltage level test can be programmed in
Feature 6. When using voltage sense mode, connection of the H2/5 VIOLET/ WHITE tachometer input is not necessary.
© 2000 Directed Electronics, Inc. Vista, CA
LED OFF SETTING
(PRESS CHANNEL 2)
Engine checking off
Voltage checking type
24 minutes (2), 60 minutes (3) run time
Constant parking light output
Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.
Low voltage check level
Auxiliary output: special accessory
Factory re-arm output
Activation pulses: 2 (2), 3 (3)
Ignition-controlled locking off
Ignition-controlled unlocking off
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents