1. Manuals
  2. Brands
  3. Avital Manuals
  4. Car Alarm
  5. AviStart 6000
  6. Installation manual

Avital AviStart 6000 Installation Manual

Remote engine starter & vehicle security system
Hide thumbs Also See for AviStart 6000:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Enlarged version
AviStart 6000 Installation Manual

Advertisement

Table of Contents
loading

Related Manuals for Avital AviStart 6000

Summary of Contents for Avital AviStart 6000

  • Page 1 AviStart 6000 Installation Manual...
  • Page 2 AviStart 6000 Installation Manual...

  • Page 3: Table Of Contents

    Programming Table for System Features ....22 Programming Table for Remote Controls ....23 AviStart 6000 Installation Manual...

  • Page 4: Important Information

    7. Turn off dome light or remove dome light fuse to prevent battery drain. This device complies with Part 15 of the FCC rules. Any changes or modifications made to the system without the express approval of Avital Technologies, Inc. could void the user’s authority to operate this equipment.

  • Page 5: Main Wiring Diagram

    Main Wiring Diagram AviStart 6000 Installation Manual...

  • Page 6: Satellite Relay Module Diagram

    Satellite Relay Module Diagram AviStart 6000 Installation Manual...

  • Page 7: 22 Pin Connector

    WHITE / LIGHT GREEN Tachometer Input 6 Pin Connector Pin Number Wire Color Description YELLOW Starter Interrupt Switch Side GRAY Heater / AC Output VIOLET Starter Interrupt Starter Side PINK Ignition Output Battery (+) PINK Ignition Output AviStart 6000 Installation Manual...

  • Page 8: Installation Procedures

    4. Sleeve these wires with vinyl tubing or electrical tape and route them through an existing rubber grommet into the engine compartment. 5. If an existing grommet is not available, drill a hole and install a snap grommet. AviStart 6000 Installation Manual...

  • Page 9: Led Indicator

    The ORANGE wire is a (-) trigger input with a 5 second arming delay. This input can be used for optional sensors such a glass sensor, radar sensor or any other type of sensor that provides a (-) ground output when triggered. AviStart 6000 Installation Manual...

  • Page 10: Alarm Armed Signal (-) Output

    NOTE: Do not connect the RED/WHITE wire to the control unit RED wire. 2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire to control unit BLACK wire. 3. Connect the RED/BLACK wire to the vehicle parking light wire. AviStart 6000 Installation Manual...

  • Page 11: Reverse Light

    If the ARM/DISARM and SILENT buttons are continually pressed, the output will stay at ground as long as the buttons are held. This output can be used for optional accessories such as window roll-up/down or any other accessory requiring a (-) input. AviStart 6000 Installation Manual...

  • Page 12: Remote Start Activated (-) Output

    14 ga PINK wire to prevent a short circuit The alarm module has an 18 ga PINK wire that must be connected with one of the satellite module 14 ga PINK wires that is connected to the vehicle ignition wire. AviStart 6000 Installation Manual...
  • Page 13 If it will not crank, you have the correct wire. 3. Connect the YELLOW wire to the ignition switch side of the starter wire. 4. Connect the VIOLET wire to the starter solenoid side of the starter wire. AviStart 6000 Installation Manual...

  • Page 14: Remote Engine Start Neutral Safety Switch Bulletin

    Currently, the only vehicles with the combined neutral safety switch that Avital is aware of are General Motors trucks, GM sport utility vehicles, GM column shift passenger cars and Dodge Dakota pickup trucks. There may be additional vehicles with the combined neutral safety switch that require the additional relay.
  • Page 15 The wire color codes are subject to change. Check all wires with a volt/ohmmeter. If you have any questions, please contact the Avital Technical Support Department. AviStart 6000 Installation Manual...
  • Page 16 Gen eral Mo tors Sport Util ity Ve hi cles, Trucks and Col umn Shift Pas sen ger Ve hi cles Dodge Da kota Pickup Trucks AviStart 6000 Installation Manual...

  • Page 17: Door Lock/Unlock

    GREEN/WHITE wire provides a 300 mA positive output. When the alarm is remotely disarmed, the GREEN/WHITE wire provides a negative output. At the same time the BLUE/WHITE wire provides a 300 mA positive output. Posi tive Trig ger Door Locks AviStart 6000 Installation Manual...
  • Page 18 AviStart 6000 Installation Manual...
  • Page 19 AviStart 6000 Installation Manual...

  • Page 20: Tach Wire (Rpm Monitoring)

    On most vehicles, the tach wire is easily accessible. If the tach wire is not accessible, there are several alternative choices. Contact Avital Technical Support Department for alternate choices. The following procedure for testing the vehicle tach wire is not exact and may vary with different vehicle make, model and year.

  • Page 21: Siren

    11. Install the 5 amp fuse in the 18 ga RED wire fuse assembly. 12. Install the 20 amp fuse in the RED/WHITE wire fuse assembly. 13. Install the two 20 amp fuses in the 10 ga RED wire fuse assemblies. AviStart 6000 Installation Manual...

  • Page 22: Mandatory Rpm Programming

    NOTE: Stop on the 14th chirp. See the "Programming Table for System Features" on page 25. 5. Press and hold the remote START button. 6. The parking lights will flash two times to confirm the RPMs have been memorized. 7. Release the START button. AviStart 6000 Installation Manual...

  • Page 23: Programmable Features

    6. Follow the "Secondary Action." You will hear a number of chirps to confirm that you have changed the setting of that feature. 7. Turn the ignition key "OFF." 8. Repeat steps 1-7 for any other feature you wish to program. AviStart 6000 Installation Manual...

  • Page 24: Programming Table For System Features

    -7 F (-20 C), twice for -22 F (-30 C). -7 F (-20 C) or -22 F (-30 C) Wait 3 seconds, the siren will chirp once Security Start Locks™ for OFF, twice for ON. AviStart 6000 Installation Manual...

  • Page 25: Programming Table For Remote Controls

    One-Step Remote Code ARM/DISARM Press ARM/DISARM button, the Learning button siren will chirp 1 time Wait 3 seconds, the siren will Instant Remote Control Code — chirp twice, all codes are erased Deletion out of memory AviStart 6000 Installation Manual...
  • Page 26 AviStart 6000 Installation Manual...
  • Page 27 AviStart 6000 Installation Manual...
  • Page 28 AviStart 6000 Installation Manual...

Table of Contents