2. At the ILOM -> prompt, type:
-> set /SYS keyswitch_state=diag
The system is set to run full POST diagnostics on system reset.
3. To return to your normal diagnostic settings after running POST, type:
-> set /SYS keyswitch_state=normal
Related Information
"Discover Faults Using ILOM" on page 44
■
"Locate the System" on page 45
■
"Clear a Fault" on page 49
■
"Bypassing Minor Faults" on page 46
■
▼ Locate the System
1. To turn on the Locator LED, from the ILOM service processor command prompt,
type:
-> set /SYS/LOCATE value=Fast_Blink
2. To turn off the Locator LED, from the ILOM service processor command
prompt, type:
-> set /SYS/LOCATE value=off
3. To display the state of the Locator LED, from the ILOM service processor
command prompt, type:
-> show /SYS/LOCATE
Note – You do not need administrator permissions to use the set /SYS/LOCATE
and show /SYS/LOCATE commands.
Related Information
"Discover Faults Using ILOM" on page 44
■
"Discover Faults Using POST" on page 44
■
Handling Faults
45