Fujitsu SPARC Enterprise T5140 Administration Manual page 50

7. Configure the new hard drive.
Type the following command:
# cfgadm -c configure Ap-Id
For example:
# cfgadm -c configure c1::dsk/c1t3d0
The green Activity LED flashes as the new disk at c1t3d0 is added to the device
tree.
8. Verify that the new hard drive is in the device tree.
Type the following command:
# cfgadm -al
Ap_Id
c1
c1::dsk/c1t0d0
c1::dsk/c1t1d0
c1::dsk/c1t2d0
c1::dsk/c1t3d0
c1::dsk/c1t4d0
c1::dsk/c1t5d0
c1::dsk/c1t6d0
c1::dsk/c1t7d0
usb0/1
usb0/2
usb0/3
usb1/1
usb1/2
usb2/1
usb2/2
usb2/3
usb2/4
usb2/4.1
usb2/4.2
usb2/4.3
usb2/4.4
usb2/5
#
Note that c1t3d0 is now listed as configured.
34 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
Type Receptacle
scsi-bus connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
disk connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
usb-storage connected
unknown empty
usb-hub connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
Occupant Condition
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
configured ok
unconfigured ok
configured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok