Hot-Plug A Nonmirrored Disk - Fujitsu SPARC Enterprise T5140 Administration Manual

5. To check the status of a RAID rebuild, type the following command:
# raidctl
For example:
# raidctl -l c1t0d0
Volume
----------------------------------------------------------------
c1t0d0
This example indicates that RAID volume c1t1d0 is resynchronizing.
If you type the command again once synchronization has completed, it indicates
that the RAID mirror is finished resynchronizing and is back online:
# raidctl -l c1t0d0
Volume
----------------------------------------------------------------
c1t0d0
For more information, see the raidctl(1M) man page.
Related Information
"Disk Slot Numbers" on page 35
■
"Hot-Plug a Nonmirrored Disk" on page 30
■

▼ Hot-Plug a Nonmirrored Disk

1. Verify which hard drive corresponds with which logical device name and
physical device name.
See
Ensure that no applications or processes are accessing the hard drive.
30 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
Sub
Disk
0.0.0
0.1.0
Sub
Disk
0.0.0
0.1.0
"Disk Slot Numbers" on page
Size Stripe Status
Size
136.6G N/A SYNC
136.6G GOOD
136.6G GOOD
Size Stripe Status
Size
136.6G N/A OPTIMAL
136.6G GOOD
136.6G GOOD
35.
Cache RAID
Level
OFF RAID1
Cache RAID
Level
OFF RAID1