4 Replacement Procedures
4.7
Base assembly
Removing the Base assembly
To remove the base assembly, follow the steps below and refer to Figure 4-7 and 4-8.
1. Loosen the screw fixing the access cover and remove the access cover.
2. Take out the tab under the cover.
3. Lift up the flip of the connector and disconnect the ExpressCard FPC from the
connector CN2110 on the system board while holding the tab.
ExpressCard FPC
Tab
Flip
4-18
[CONFIDENTIAL]
Access cover
CN2110
Figure 4-7 Removing the base assembly (1)
Screw
PORTÉGÉ R600 Maintenance Manual (960-709)
4.7 Base assembly