Dc-In Harness - Toshiba R600 S4202 - Portege - Core 2 Duo 1.4 GHz Maintenance Manual

4 Replacement Procedures

4.15 DC-IN harness

Removing the DC-IN harness
To remove the DC-IN harness, follow the steps below and refer to Figure 4-20.
1. Disconnect the DC-IN harness from the connector CN8800 on the system board and
remove the DC-IN harness from the slot.
Installing the DC-IN harness
To install the DC-IN harness, follow the steps below and refer to Figure 4-20.
1. Set the DC-IN harness into the guide of the slot and connect the DC-IN harness to
the connector CN8800 on the system board.
4-38 [CONFIDENTIAL]
Figure 4-20 Removing the DC-IN harness
PORTÉGÉ R600 Maintenance Manual (960-709)
4.15 DC-IN harness
DC-IN harness
Guide
CN8800