Base Assembly; Removing The Base Assembly (1) - Toshiba PORTÉGÉ R700 Series Maintenance Manual

4 Replacement Procedures
4.8

Base assembly

Removing the Base assembly
To remove the base assembly, follow the steps below and refer to Figure 4-11 to 4-13.
1. Take out the tab under the base assembly.
2. Lift up the flip of the connector and disconnect the ExpressCard FPC from the
connector CN2520 on the system board while holding the tab.
ExpressCard FPC
4-22 [CONFIDENTIAL]
Tab
Figure 4-11 Removing the base assembly (1)
Flip
CN2520
PORTÉGÉ R700 Maintenance Manual (960-833)
4.8 Base assembly