Switching The Basic Unit On/Off - Fujitsu PRIMERGY BX600 S2 Operating Manual

Preparation for Use and Operation
5.2

Switching the Basic Unit ON/OFF

V
CAUTION!
Make sure that the PRIMERGY BX600 S2 basic unit is connected to
the mains for at least one minute before pressing the power ON/OFF
button to switch the system ON.
If, after switching the basic unit ON, you can only see flickering stripes
on the attached monitor, switch the system OFF immediately (see
chapter "Troubleshooting and Tips" on page
The system ON/OFF power button does not disconnect the system
from the mains voltage. To completely disconnect it, you must remove
the power plugs from the sockets.
Switching ON the Basic Unit ( Basic Unit is Powered OFF)
Ê Press the basic unit power ON/OFF button (position 2 in
page 50) for 2 seconds. Depending on the BIOS settings, the server blades
can be switched on automatically one after another according to the slot
numbering (see
Ê If necessary, switch ON the required server blades (see
Server Blades ON/OFF" on page
The basic unit is switched ON and the activated server blades perform a system
test and boot the operating system.
Switching OFF the Basic Unit (System is Powered ON)
The basic unit is operating (server blades are also switched ON).
Ê For graceful shutdown of all server blades, press the system power
ON/OFF button (position 2 on
server blades will then be powered OFF.
Ê For hard shutdown of all server blades, press the system power ON/OFF
button (position 2 on
blades will be powered OFF immediately.
PRIMERGY BX600 S2 Basic Unit
figure 29 on page
54).
figure 15 on page
figure 15 on page
Switching the Blade Server ON/OFF
155).
72).
50) for 4 seconds. The
50) for 10 seconds. The server
figure 15 on
"Switching the
53