Switching An Application Unit On/Off; Operating System And Other Software - Fujitsu SE700 Operating Manual

Application Unit AU47

2.2 Switching an Application Unit on/off

The Application Units are switched on and off individually or together with the other compo-
nents of the SE server.
Information on switching on and starting the SE server and on switching it off and shutting
it down is provided in the
off".
Other On/Off options
iRMC
●
The iRMC offers various options for switching the server on and off, e.g. via the Power
OnOff page of the iRMC Web interface.
Time-controlled power-on/shutdown
●
Using the iRMC, you can configure that the server is switched on/off controlled by timer
After power failure
●
An Application Unit which is switched on reboots automatically following a power failure
(depending on the settings in the BIOS setup or in the iRMC).
Power Button Override
●
The Application Unit
(for approximately 4 - 5 seconds).
v
Wake up On LAN (WOL)
●
An Application Unit is switched on by a command via the LAN (Magic Packet

2.3 Operating system and other software

Application Units are supplied with the software ordered and are configured by Customer
Support.. If you require further software, please contact the Fujitsu Technology Solutions
Sales department.
You will find information on how to install software and how to configure Application Unit in
the "Operation and Administration" manual [5].
22
Basic Operating
can be switched off by pressing and holding down the On/Off button
CAUTION!
There is a risk that data may be lost!
Manual" [1], section "Switching the server on and
Application Unit
TM
).
U41861-J-Z126-1-76