Preparing The Audio Input System; Connecting A Microphone To The Mic In Connector - Sony PDW-F800 Operation Manual

8
Repeat steps 4 to 7 until the chart stays
in focus all the way from wide angle to
telephoto.
9
Tighten the F.f or F.B ring fixing
screws.
Preparing the Audio
Input System
Connecting a microphone to the
MIC IN connector
You can attach the ECM-680S stereo microphone
(not supplied) to the microphone holder of the
HDVF-20A viewfinder (not supplied).
1
Loosen the screw and open the
microphone holder clamp.
Microphone holder clamp
2
Place the microphone in the
microphone holder.
1 Wind the microphone spacer (sheet
type, supplied with this unit and the
ECM-680S) around the microphone,
while peeling off the protective sheets
on both sides of the microphone
spacer.
2 Place the microphone in the holder so
that "UP" is at the top.
3 Close the microphone holder.
4 Tighten the screw.

Preparing the Audio Input System

1
2
47