Sony PDW-F800 Operation Manual page 198

No. Page
27/28 UP
CONVERTER
[800]
28/–
SHUTTER
SELECT
a) The setting of this item is overridden by the setting of
Other BEFORE END when TYPE DETECTION in
198 Menu List
Item Settings
UP CON PROCESS FIELD/ADPT
UC DETAIL (–99 to 99)
LEVEL
UC CRISPENING (–8 to 7)
UC DETAIL LIMIT (–99 to 99)
UC LV DEPEND (–8 to 7)
LVL
UC DTL 3.2M/4.5M/
FREQUENCY 5.0M/4.0M
UC DTL H/V (–3 to 4)
RATIO
SHUTTER SELECT SECOND/
DEGREE
ADD 360.0 to 180.0 to
(only when 4.5 (upper limit
SHUTTER SELECT of shutter angle
is set to "DEGREE") degrees)
DEL –
(only when
SHUTTER SELECT
is set to "DEGREE")
1 to 6 Display only
(only when
SHUTTER SELECT
is set to "DEGREE")
Description
Selects the conversion source picture when
SD is upconverted to HD.
FIELD: Use the field picture.
ADPT: Optimize the ratio of conversion from
the frame or field picture.
Adjusts the sharpness of edge enhancement
by the upconverter.
Sets the amplitude width at which the
upconverter does not emphasize low-
amplitude signals.
Sets the maximum level of edge enhancement
by the upconverter.
Sets the luminance of edge enhancement by
the upconverter.
Sets the center frequency and frequency
properties of edge enhancement by the
upconverter.
3.2M: 3.2 ± 1.1 MHz
4.5M: 4.5 ± 1.4 MHz
5.0M: 5.0 ± 0.7 MHz
4.0M: 4.0 ± 2.0 MHz
Sets the horizontal/vertical ratio of edge
enhancement by the upconverter.
Selects the shutter speed display unit.
SECOND: Second units
DEGREE: Degree units (shutter opening
angle)
See page 68 for more information about
degree unit settings.
Registers a shutter degree setting in an empty
number from 1 to 6 (this item is disabled if no
number is empty).
Deletes the setting assigned to a number from
1 to 6 (numbers with no settings assigned
cannot be selected).
Displays the shutter opening angle assigned to
number 1 to 6, and the corresponding speed in
second units, as calculated on the basis of the
selected frame rate.This differs as follows,
depending on the setting of SYSTEM
FREQUENCY.
59.94i, 29.97P: 1: 216.0, 2: 180.0, 3: 90.0, 4:
45.0, 5: 22.5, 6: 11.2
50i, 25P: 1: 180.0, 2: 150.0, 3: 90.0, 4: 45.0,
5: 22.5, 6: 11.2
23.98P: 1: 180.0, 2: 172.8, 3: 144.0, 4: 45.0,
5: 22.5, 6: 11.2
the BATTERY 2 page is set to "OTHER".