Adjusting The Flange Focal Length - Sony PDW-F800 Operation Manual

securing rubber be put on the lens locking lever as
illustrated above.
4
Connect the lens cable to the LENS
connector.
5
Secure the lens cable with the cable
clamps.
46

Adjusting the Flange Focal Length

Adjusting the Flange
Focal Length
If the lens does not stay in focus properly as you
zoom from telephoto to wide angle, adjust the
flange focal length (the distance from the plane of
the lens mounting flange to the imaging plane).
Make this adjustment after mounting or changing
the lens.
The position of the controls for adjusting the flange
focal length vary somewhat from lens to lens. Check
the identification of the various controls in the lens
manual.
1
Set the iris to manual.
2
Open the iris. Place the flange focal
length adjustment chart about 3 m (10
ft) away from the camera, lit well
enough to provide a satisfactory video
output level.
3
Loosen the fixing screws on the F.f or
F.B ring (flange focal length adjustment
ring).
4
Use manual or power zoom to set the
lens to telephoto.
5
Point the camera at the chart by turning
the focus ring and focus on it.
6
Set the zoom ring to wide angle.
7
Turn the F.f or F.B ring until the chart
is in focus, being careful not to disturb
the focus ring.
About 3 m (10 ft)