Sony PDW-F800 Operation Manual page 223

ASSIGN 1/3/4 switches allow you to display or
not to display all markers.
b) This function cannot be assigned to the RET
button on the lens.
c) Even if the RETURN VIDEO item is set to OFF
on the ASSIGNABLE SW page of the
OPERATION menu, you can use this switch to
display the image of the return video signal on
the viewfinder.
d) Only the Assign 3 SEL and Assign 4 SEL screens
appear.
e) Video momentarily becomes black and audio is
momentarily muted when the digital extender is
switched on and off.
f) This does not appear if nothing is assigned in the
Assign menu.
Functions to be assigned to the ASSIGN 2
(slide-type) switch
Function Content
OFF Assigns no function.
FRONT MIC Assigns the function that
switches between stereo and
monaural when a stereo
microphone is connected.
PICTURE Assigns execution of
CACHE recording in picture cache
mode.
SUPER Assigns a mixing switch
(VFDISP&M function that selects mixing or
ENU) no mixing of superimposed
viewfinder and menu text data
into the video signals output
from the SDI OUT 2 or TEST
OUT connector, when SDI
OUT 2 SUPER or TEST OUT
SUPER on the OUTPUT 1
page of the OPERATION
menu are set to ON.
MARKER Assigns the function that
displays or hides all
a)
markers.
REC VIDEO Switches the recording target
SOURCE video between the video shot
by the camera and the video
input from an external device
(VBS or SD-SDI/HD-SDI).
ZEBRA Assigns the zebra pattern
display function.
FREEZE MIX Assigns the function that
mixes a still picture
(monochrome) and camera
video (color) (effective for
framing shots).
Function
DIGITAL
EXTENDER
CLIP CONT
REC
UA01 to
d)
UA10
a) Even when the MARKER item is set to OFF on
the MARKER page of the USER menu, the
ASSIGN 2 switch allows you to display or not to
display all markers.
b) The optional CBK-SC02 Analog Composite
Input Board is required for VBS signal input. The
optional CBK-HD01 HD/SD SDI Input Board is
required for SD-SDI/HD-SDI signal input.
c) Video momentarily becomes black and audio is
momentarily muted when the digital extender is
switched on and off.
d) This does not appear if nothing is assigned in the
Assign menu.
Note
For functions that are assigned to the ASSIGN 2
(slide-type) switch, you cannot change those
settings using other menus. The function assigned
to the ASSIGN 2 switch takes precedence over the
menu setting.
3
Select the desired function, and press
the MENU knob.
The function is assigned, and the
ASSIGNABLE SW page appears again.
Operation of the ASSIGN 1/2/3/4 switches when
UA01 to UA10 are assigned
When an on/off switchable function (or menu
item) is assigned to one of the ASSIGN 1/2/3/4
switches, each time the switch is pressed toggles
the function on or off.
When another type of menu item is assigned,
pressing the switch displays the item and its
setting value on the viewfinder screen.
b) You can then change the setting by pressing and
turning the MENU knob.
The viewfinder screen display disappears
approximately three seconds after the last
operation.
Adjustments and Settings from Menus
Content
Assigns the function that
c) electronically magnifies the
central part of the picture. (All
video output is magnified,
including recorded video.)
Assigns the function that
turns the Clip Continuous Rec
function on and off.
Assigns the items assigned in
the ASSIGN SEL menu.
223