Sony PDW-F800 Operation Manual page 268

SUB Clip NG The In and Out point positions are
invalid. Set correct In and Out
points.
MAX# SB The total number of sub clips is
CLP over the upper limit (300).
Resolution An attempt was made to register a
clip in a clip list with a different
resolution.
CL OVER The total duration of sub clips in
DUR the current clip list is over the
upper limit (24 hours).
FAN Stopped The main unit or drive fan has
DR-FAN Stop stopped. Avoid use under high
temperatures, turn off the power,
and contact a Sony service
representative.
NVRAM NG! An error was detected while
accessing internal memory. Power
the unit off and contact a Sony
service representative.
Update Err! A firmware update failed. Power
the unit off and contact a Sony
service representative.
Unknown An unsupported USB device was
USB connected to this unit.
NO USB A USB flash drive write operation
MEMORY! was attempted with no USB flash
drive connected.
USB A write inhibited USB flash drive
MEMORY was connected with MEMORY
INHIBIT! REC on the MEMORY REC page
USB M. INHI of the OPERATION menu set to
ENABL.
USB The connected USB flash drive
MEMORY was not usable when a USB flash
ERROR! drive write operation was
attempted.
M. Shortage A USB flash drive write operation
was attempted without enough
free memory in the USB flash
drive.
USB A USB flash drive write operation
MEMORY was attempted without free
FULL! memory in the USB flash drive.
MEM REC A USB flash drive write operation
NG! failed with MEMORY REC on the
MEMORY REC page of the
OPERATION menu set to
ENABL.
268 Operation Warnings
M. access! An attempt was made to switch
GUI screens during a USB flash
drive write operation.
Alarm messages during thumbnail
search, scene selection, and clip list
operations
An alarm message may appear in the LCD
monitor during thumbnail search, scene selection,
and clip list operations. In that case, take the
action indicated in the following table.
Cannot The clip cannot be expanded into
Expand Clip more blocks. This alarm appears
any Further. when the DISP SEL/EXPAND
button is pressed when the number
of blocks is maximum, or when
the duration of an expanded
thumbnail is one frame.
Selected The selected essence mark does
Essence Mark not exist.
Does not This alarm appears in the essence
Exist. mark selection screen when the
specified essence mark does not
exist on the disc.
Sub Clip is The temporal relationship between
Invalid. Set the specified In and Out points in a
Appropriate TRIM operation (see page 135) is
IN/OUT not correct. Reset so that the value
Points. of the Out point timecode is larger
than the value of the In point
timecode.
Duration of The total duration of the current
One Clip List clip list exceeds the upper limit of
must be Less 24 hours as the result of an Add
than 24 Sub Clips (see page 133) or Trim
Hours. Sub Clip (see page 135) operation.
No More Sub The total number of the sub clips
Clips can be of the current clip list exceeds the
Added to the upper limit of 300 as the result of
Clip List. an Add Sub Clips (see page 133)
or Trim Sub Clip (see page 135)
operation.
Sub Clip does An attempt is made to execute a
not Exist. Move Sub Clips (see page 135),
Trim Sub Clip (see page 135),
Delete Sub Clips (see page 136),
or Set Start Time Code (see
page 136) operation with no sub
clips in the current clip list.