Fujitsu M3097G Oem Manual page 63

(1) SET WINDOW command: COMMAND phase (initiator Æ target)
The SET WINDOW command is used to set a window.
The CDB of this command is shown in the following illustration.
7 6
Byte 0
Logical unit number
1
2
5
6 (MSB)
7
8
9
a. TRANSFER LENGTH: Bytes 6 to 8
Specifies the number of window data bytes sent in the DATA OUT phase.
A zero (0) means that no data is to be transferred; this situation is not
considered an error.
If the number of bytes is not enough (less than 48) to set a window, the scanner
returns the following error information:
f Status:
f Sense key: X©5π (ILLEGAL REQUEST)
4 $ 38
5 4
Operation code X©24π
(Reserved)
Transfer length
Control byte
B©00001π (CHECK CONDITION)
3 2 1
(Reserved)
0
(LSB)