Fujitsu M3097G Oem Manual page 110

f DBD (disable block descriptor): Byte 1
When the DBD bit is 1, the target must not return the mode descriptor block in
the Data In phase. When this bit is 0, the target may or may not return the
block.
This bit must be 0.
f PC (page control): Byte 2
PC specifies the type of parameter returned, defined as follows:
PC
00
01
10
11
Only 00 (current value) can be set. Other values cause the following error:
Status: B©00001π (CHECK CONDITION)
Sense key: X©05π (ILLEGAL REQUEAT)
Page code: Byte 2
The page code specifies the page to be reported. The following are supported:
Page code
X©00π
Xπ01π
X©02π
X©03π
X©04π to X©3Dπ
X©3Dπ
X©3Eπ
X©3Fπ
f Allocation length: Byte 4
The allocation length specifies the storage area allocated by the initiator for
the mode sense data in bytes.
0 means no data is transferred. This is not an error.
Parameter type
Current value
Changeable value
Default
Saved value
Description
Donπt care (IGNORE)
Reserved
Not supported
Not supported
Reserved
Lamp timer
Job separation sheet
Reserved
4 $ 85