Fujitsu M3097G Oem Manual page 149

f Description
- Upon receiving the detected paper information from the read command
(Data type code = Xπ81π), the driver or application software must specify
the window area (Set window command Byte 6 to 15) and the paper size
(Set window command Vender unique parameter byte 35) using the set
window command.
- The detected paper information is accessed with the read command (Data
type code = Xπ81π).
- Once paper is fed by issuing the object position (Unload object) command,
the direction to which paper is loaded (paper direction) is accessed with the
read command (Data type code = Xπ81π).
Format of detected paper information
Byte 0
Reserved
Byte 1
Byte 2 Job separation sheet
Byte 3 Paper size
Byte 4
Byte 5
Reserved
Byte 6
Byte 7
f Job separation sheet
Xπ80π: Job separation sheet is detected.
Xπ00π: Job separation sheet is not detected.
f Paper size
b7 b6 b5
Reserved
Note:
Bits 4, 5, and 6 are effective only when image data has been read. An ™*1∫ in
Figure 1.1.1 shows the effective timing.
D $ 4
Byte 2
Byte 3
b4 b3 b2 b1 b0
0000: Undefined
0001: Undefined
0010: Undefined
0011: A3 or DL
0100: A4 or LT
0101: A5
0110: Undefined
0111: Undefined
0: Portrait 1: Landscape
0: Paper size detected, when the paper is fed from ADF.
1: Paper size not detected, when the paper is fed from ADF.
0: The Paper is loaded into ADF (Except 1st page).
1: The paper is ejected from ADF.
Following paper size is detected.
1000: Undefined
1001: Undefined
1010: Undefined
1011: Undefined
1100: B4
1101: B5
1110: Undefined
1111: Undefined