Manual Feed Mode Setting - Fujitsu C150-E146-02EN Operator's Manual

Manual Feed Mode Setting

In this mode, the scanner waits for some predetermined time without issuing "Paper Empty" after all
documents are read. This predetermined time (time-out limit) is specified by Setup mode. Therefore
you can set next documents on ADF chute without interrupting reading operation. The procedures for
setting manual feed mode are as follows.
1 Turn the power ON and verify that
"Scanner Ready" is displayed on LCD.
2 Press then the scanner displays
Screen M2.
3 Press then the scanner displays
Screen M3.
4 Press then the scanner displays
Screen M4.
5 Select "Yes" by pressing
.
6 Press to return to "Scanner Ready"
screen. Note that "Manual Feed" is
shown on LCD. This means that the
scanner is in Manual Feed mode.
<Screen M1>
<Screen M2>
<Screen M3>
<Screen M4>
. Then press
<Screen M1>
3-3