1. Follow the instructions in
Before You
2. Align the screw hole on the status light board with the screw hole on the computer base.
3. Replace the screw that secures the status light board to the computer base.
4. Slide the status light board cable into the connector on the system board and press down on the connector latch to secure the cable.
5. Replace the palm rest (see
6. Replace the keyboard (see
7. Replace the optical drive (see
8. Follow the instructions from
9. Replace the module cover (see
10. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Replacing the Palm
Rest).
Replacing the
Keyboard).
Replacing the Optical
Drive).
step 5
to
step 7
in
Replacing the Hard
Replacing the Module
Cover).
Battery).
Drive.