Fujitsu 8000 SERIES User Manual page 59

8 Connect flat cables.
The connector of the primary IDE cable, which is marked "To the motherboard" in the figure
below, is connected to the primary IDE connector in the PC unit.
On standard models, to install the first disk, connect the master connector of the primary IDE
cable to the connector of the internal hard disk. When installing the second one, connect the
slave connector of the primary IDE cable connected to the first hard disk to the connector of
the internal hard disk.
< Primary IDE cable (80 pins)>
Pin 1 Pink line
Blue connector
9 Connect the power cable.
Connect an unused power cable in the PC unit to the installed internal hard disk.
Connect the option here
To the
to configure it as a slave.
motherboard
SLAVE MASTER
Connect the option here to
configure it as the master.
49