Fujitsu 8000 SERIES User Manual page 43

Secondary IDE
Primary IDE
*1: CD-ROM drive pre-installed. When a magneto-optical disk is selected as a custom-made option, however, a
magneto-optical disk drive is installed.
*2: CD-ROM drive preinstalled when a magneto-optical disk is selected as a custom-made option.
*3: The internal hard disk bay accepts a hard disk only.
*4: Installed to the 5" front access bay when the front access unit for HDD is selected as a custom-made option.
<Primary IDE cable (80 pins)>
Pin 1 Pink line
Blue connector
Pin 1 Red line
<Secondary IDE cable (40 pins)>
Point
• For this PC, the number of pins in a cable differs between those connected to the primary and
secondary IDEs. Use a 80-pin cable for connection to the primary IDE and a 40-pin one for
connection to the secondary IDE.
• By default, the pre-installed internal IDE device is configured to Cable-Select.
• Be sure to connect the hard disk that runs OS to the primary IDE connector as a master. If it is
connected as a slave or to the secondary IDE connector, OS may not run.
• For combination of the "master" and "slave" of the secondary IDE, refer to "Installing front access
bay options".
SLAVE
To the
motherboard
SLAVE
Front side
MASTER
Connect the option
here to configure it
as the master.
MASTER
Third (master) *1
*2
Fourth (slave)
First (master) (hard
*4
disk pre-installed)
*3
Second (slave)
Connect the option
here to configure it
as a slave.
33