Airwave Setup; Controller Setup (Master And Local) - Dell PowerConnect W-Airwave Manual

Dell PowerConnect W-ArubaOS 6.0.1 or later

NOTE: ArubaOS 6.0.1 can report RF utilization metrics, while ArubaOS 6.1 is necessary to also obtain classified interferer
information.
Access points - Dell PowerConnect W AP-105, AP-92, AP-93, AP-125, AP-124, AP-134, AP-135

Controllers - Dell PowerConnect W 600 Series or 3000 Series


AirWave Setup

Follow these steps in AirWave:
1. Navigate to AMP Setup > General.
2. In the Additional AMP Services section, set Enable AMON Data Collection to Yes, as shown in
Figure 5
3. Select Save.

Controller Setup (Master And Local)

CAUTION: Enabling these commands on ArubaOS versions prior to 6.0.1.0 can result in performance issues on the controller. If
you are running previous firmware versions such as ArubaOS 6.0.0.0, you should upgrade to ArubaOS 6.0.1 (to obtain RF
utilization metrics) or 6.1 (to obtain RF utilization and classified interferer information) before you enter this command.
Use SSH to access the controller's command-line interface, enter enable mode, and issue the following
commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP-IP>
(Controller-Name) (config) # write mem
8 | Configuring AirWave for Global Dell PowerConnect W-Series Infrastructure
AMON Data Collection setting in AMP Setup> General
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
Figure 5: