Table of Contents
Advertisement
Back to Contents Page
Display
Dell™ Inspiron™ N4010 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Hinges
Hinge Caps
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly
Removing the Display Assembly
1. Follow the instructions in
Before You
2. Remove the battery (see
Removing the
3. Follow the instructions from
4. Remove the module cover (see
5. Remove the memory module(s) (see
6. Remove the keyboard (see
7. Remove the palm rest (see
8. Remove the two screws that secure the display assembly to the computer base.
9. Turn the computer over and open the display as far as possible.
10. Disconnect the antenna cables from the Mini-Card(s) (see
11. Disconnect the display cable from the connector on the system board, and remove the display cable grounding screw.
Begin.
Battery).
step 3
to
step 4
in
Removing the Optical
Removing the Module
Cover).
Removing the Memory
Module(s)).
Removing the
Keyboard).
Removing the Palm
Rest).
Removing the
Removing the
Drive.
Mini-Card(s)).
Battery) before working inside the
Advertisement
Table of Contents
