Table of Contents
Advertisement
Back to Contents Page
Before You Begin
Dell™ Inspiron™ N4010 Service Manual
Recommended Tools
Turning Off Your Computer
Before Working Inside Your Computer
This manual provides procedures for removing and installing components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:
You have performed the steps in
l
You have read the safety information that shipped with your computer.
l
A component can be replaced or—if purchased separately—installed by performing the removal procedure in the reverse order.
l
Recommended Tools
The procedures in this document may require the following tools:
Small flat-blade screwdriver
l
Phillips screwdriver
l
Plastic scribe
l
BIOS executable update program available at support.dell.com
l
Turning Off Your Computer
CAUTION:
To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
1. Save and close all open files and exit all open programs.
2. Shut down the operating system:
®
Windows
Vista:
Click the Start button
®
Windows
7:
Click the Start button
3. Ensure that the computer is turned off. If your computer did not automatically turn off when you shut down the operating system, press and hold the
power button until the computer turns off.
Before Working Inside Your Computer
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
mounting bracket. Hold a component such as a processor by its edges, not by its pins.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
Turning Off Your Computer
and
Before Working Inside Your
, click the arrow
, and then click Shut Down.
and then click Shut Down.
Computer.
Advertisement
Table of Contents
