12. Make a note of the Mini-Card antenna cables and display cable routing and remove the cables from the routing guides.
13. Hold the display assembly in place and remove the four screws that secure the display assembly to the computer base.
14. Lift and remove the display assembly out of the computer base.
1
display cable grounding screw
3
Mini-Card antenna cables
5
display assembly
Replacing the Display Assembly
1. Follow the instructions in
Before You
2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3. Route the Mini-Card antenna cables and display cable through the routing guides.
4. Connect the display cable to the connector on the system board, and replace the display cable grounding screw.
5. Connect the antenna cables to the Mini-Card(s) (see
6. Close the display and turn the computer over.
7. Replace the two screws that secure the display assembly to the computer base.
8. Replace the palm rest (see
9. Replace the keyboard (see
10. Replace the memory module(s) (see
11. Replace the module cover (see
12. Follow the instructions from
13. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel
2
display cable
4
screws (4)
Begin.
Replacing the
Replacing the Palm
Rest).
Replacing the
Keyboard).
Replacing the Memory
Module(s)).
Replacing the Module
Cover).
step 4
to
step 5
in
Replacing the Optical
Battery).
Mini-Card(s)).
Drive.