Table of Contents
Advertisement
1 Mini-Card 2 screw 3 antenna cables (2)
9. Remove the screw that secures the Mini-Card to the daughter board.
10. Lift the Mini-Card out of the connector on the daughter board.
Replacing the Mini-Card(s)
1. Follow the instructions in
Before You
2. Remove the new Mini-Card from its packaging.
CAUTION:
Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
CAUTION:
The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system
board, and realign the card.
CAUTION:
To avoid damage to the Mini-Card, never place cables under the card.
3. Insert the Mini-Card connector at a 45-degree angle into the appropriate daughter board connector. For example, the WLAN card connector is labeled
WLAN and so on.
4. Press the other end of the Mini-Card down into the slot on the daughter board and replace the screw that secures the Mini-Card to the daughter board
connector.
5. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for each Mini-
Card supported by your computer.
Connectors on the Mini-Card
Begin.
Antenna Cable Color Scheme
Advertisement
Table of Contents
