Display Assembly; Removing The Display Assembly - Dell Inspiron 13 N3010 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ N3010 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Bracket
Display Cable
Display Hinges
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the memory-module cover (see
4. Remove the memory module(s) (see
5. Remove the two screws on the bottom of the computer that secure the display assembly to the computer base.
6. Remove the keyboard (see
7. Remove the palm rest assembly (see
8. Open the display as far as possible.
9. Pull the pull-tab to disconnect the display cable from the connector on the system board.
10. Remove the display cable grounding screw.
NOTE: Open the display at a 90-degree angle to the plane.
Begin.
Battery).
Removing the Memory-Module
Removing the Memory Module(s)).
Removing the Keyboard).
Removing the Palm Rest
Removing the
Cover).
Assembly).
Battery) before working inside the