Table of Contents
Advertisement
Back to Contents Page
Processor Module
Dell™ Inspiron™ N3010 Service Manual
Removing the Processor Module
Replacing the Processor Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Processor Module
1. Follow the instructions in
Before You
2. Follow the instructions from
3. Remove the processor heat sink (see
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor module when removing or replacing the
processor module, press to apply slight pressure to the center of the processor module while turning the cam screw.
CAUTION:
To avoid damage to the processor module, hold the screwdriver such that it is perpendicular to the processor module when turning the
cam screw.
4. To loosen the ZIF socket, use a small flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1
processor module
3
pin-1 corner
CAUTION:
To ensure maximum cooling for the processor module, do not touch the heat transfer areas on the processor module thermal-cooling
assembly. The oils in your skin can reduce the heat transfer capability of the thermal pads.
CAUTION:
When removing the processor module, lift the processor module straight up. Be careful not to bend the pins on the processor module.
5. Lift the processor module from the ZIF socket.
Replacing the Processor Module
Begin.
step 2
to
step 16
in
Removing the System
Removing the Processor Heat
2
ZIF socket
4
ZIF-socket cam screw
Removing the
Board.
Sink).
Battery) before working inside the
- Quick Links:
- Removing the Hard Drive
Hide quick links:
Advertisement
Table of Contents
