Haier LE32C1320 Owner's Manual page 12

1. Install the stand; place the TV on a solid
surface.
Ensure that the TV is placed in a position to
allow free flow of air. Do not cover the
ventilation openings on the back cover.
To prevent any unsafe situations, no naked flame
sources, such as lighted candles, should be
placed on or in the vicinity.
Avoid heat, direct sunlight and exposure to rain
or water. The equipment shall not be exposed
to dripping or splashing.
2. Connect the antenna cable or CATV cable
to the ANT IN 75 Ω aerial socket at the
back of the TV set.
3. Remote control:
Remove the cover of the battery compartment.
Insert the 2 supplied batteries (Type AAA 1.5V).
Min.
1 m
4. Power:
Insert the power cord into a wall socket with
AC power supply. You can check the LED status
on the front panel. If the LED lights up blue, it
means that the TV set is powered on. If the LED
lights up red, it means that the TV set is in
standby mode.
5. Turn the TV on:
Press the Power key on the remote control or
the TV's front panel control. The TV will turn on
in a few seconds.
CABLE
12
Power Key