Initializing NVRAM
You can restore the original factory default menu settings by initializing NVRAM.
1. Press Menu.
2. Press
until Configure appears, and then press
3. Press
until Maintenance appears, and then press
4. Press
until Init NVRAM appears, and then press
5. The Init NVRAM Are you sure? message appears on the operator panel. Press
6. Turn off the printer, and then on again.
Initializing NVRAM from Network settings
You can initialize IP Address by initializing NVRAM from Network settings.
1. Press Menu.
2. Press
until Configure appears, and then press
3. Press
until Network appears, and then press
4. Press
until Init NVRAM appears, and then press
5. The Init NVRAM Are you sure? message appears on the operator panel. Press
6. Turn off the printer, and then on again.
or
.
or
.
or
.
or
.
or
.
or
.
.
.