Dell 3000cn Color Laser Printer User Manual page 41

3. Press until Configure appears, and then press
4. Press until Network appears, and then press
5. Press until TCP/IP appears, and then press
6. Press until IP AddressSetup appears, and then press
7. Press until Panel appears, and then press
8. Press .
9. Press until IP Address appears, and then press
10. The cursor is located at the first digit of the IP address. Press
11. Press .
The cursor moves to the next digit.
12. Repeat steps 10 and 11 to enter all of the digits in the IP address, and then press
13. Press .
14. Press until Subnet Mask appears, and then press
15. Repeat steps 10 to 11 to set Subnet Mask, and then press
16. Press .
17. Press until Gateway Address appears, and then press
18. Repeat steps 10 to 11 to set Gateway Address, and then press
19. Turn off the printer, and then turn it on again.
The IP address is assigned to your printer. You can verify the setting by opening the web browser on any computer on the
network and enter the IP address into the URL line. If the IP address is set up correctly, the Dell Printer Configuration Web
Tool displays in your browser.
You can also assign the IP address to the printer when installing the printer drivers with installer. When you use the Network
Installation feature, and the IP AddressSetup is set to AutoIP on the operator panel menu, you can set the IP address
from 0.0.0.0 to the desired IP address on the printer selection window.
Verify the IP Settings
1. Print another Printer Settings page.
2. Look under the TCP/IP heading on the Printer Settings page to make sure the IP address, netmask, and gateway are
what you expected.
or
Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping
followed by the new printer IP address (for example, 192.168.0.11):
or .
or .
or .
or .
.
or .
to enter the numbers for the IP address.
or .
.
or .
.
.