Testing The Configuration; Step 1 - Connect To The Amigopod Wireless Network - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Cisco wlc integration guide

Hide thumbs Also See for PowerConnect W Clearpass 100 Software:

Table of Contents

Testing the Configuration

Now that the configuration of both the Cisco WLC and the Amigopod solution is complete, the

following steps can be followed to verify the setup.

Use a test laptop to attempt to connect to the advertised amigopod_guest wireless network. The

screen capture below shows the interface used on a Windows 7 based laptop. Although the

process differs from laptop to laptop depending on the wireless card drivers installed and

different operating systems in use, the basic premise of connecting to the Guest Wireless

network should be fundamentally the same. Refer to your laptop manufacturer's documentation

on the procedure for connecting to wireless networks if you experience an issue connecting to

the guest network..

Note: If the amigopod_guest wireless network is not visible from the test laptop, double check

the configuration of the Cisco WLC and potentially source a second wireless test device to see if

the problem is laptop specific.

CONFIDENTIAL

Table of Contents

Do you have a question about the PowerConnect W Clearpass 100 Software and is the answer not in the manual?

Amigopod