Pitch Bending - American Audio DCD-PRO240 Operating Instructions Manual

BASIC OPERATIONS (CONT)
PITCH BEND:
10.
This function will momentarily increase or decrease a tracks playback speed. There are two ways to operate
this function with the (-) & (+) PITCH BUTTONS (12 & 13) or with the JOG WHEEL (16). The maximum pitch
bend percentage allowed is +/- 16%. The pitch bend function will work in conjunction with the PITCH SLIDER
(11) pitch setting. The PITCH SLIDER (11) adjustment can be changed to range from +/-8%, +/-12%, or +/-
16%. For example, if the PITCH SLIDER (11) is set to a 2% pitch gain the pitch bending process will begin at
ll continue to the maximum of -
2% and wi
PITCH BEND BUTTONS (12 & 13):
The (+) PITCH BEND BUTTON (12) will provide a speed bump and the (-) PITCH BEND BUTTON (13) will pro-
vide a slow down. The extent to which the speed changes is proportionate to the amount of time the button
is pressed. For example, if the (+) PITCH BEND BUTTON (12) is held down continuously, the disc speed will
increases and will continue to increase until reaches a maximum of 100% speed gain. When you release the
(+) PITCH BEND BUTTON (12) the disc speed will automatic
Figure 11
Figure 13
American Audio
©
/+16%.
Holding down or tapping on the (+) PITCH
BEND BUTTON (12) will provide a speed
bump in the playback pitch.
Holding down or tapping on the
(-) PITCH BEND BUTTON (13) will
provide a slow down in the play-
back pitch.
JOG WHEEL (16):
The JOG WHEEL (16) will temporarily bend the pitch if a track is in play
mode Rotating the wheel in a clockwise direction will increase your
track pitch and rotating the wheel in a counter-clockwise direction will
slow your track pitch. The speed you rotate the JOG WHEEL (16) will
determine pitch bend percentage (%).
- www.AmericanAudio.us - DCD-PRO240™ Instruction Manual Page 16
®
ally return to
it's previous speed.
Figure 12