Lenovo ThinkServer RD120 Hardware Maintenance Manual page 99

11. Reconnect the external cables; then, reconnect the power cords and turn on
the peripheral devices and the server.
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
Installing a SATA tape drive in a 2.5-inch model server
To install a tape drive in a 2.5-inch model server, complete the following steps.
1. Remove the fan-bracket assembly.
2. Remove the filler panel from the tape-drive bay.
3. If the tape-drive assembly has a space filler on top of the drive, remove it now.
4. From the inside of the server, thread the tape-drive end of the cables for your
tape drive through the rear of the tape-drive bay and out the front of the
server.
5. Connect the cable or cables to the back of the tape drive.
6. Push the tape-drive assembly into the tape-drive bay, gently pulling the cables
farther into the server as you do so, until the tape-drive assembly stops.
7. Push the tray handle to the closed (locked) position.
8. Connect the cable connectors to the following system-board connectors (see
"System-board internal cable connectors" on page 11 for the location of the
connectors):
v Signal connector: SATA tape drive signal connector, J102
v Power connector: tape-drive power connector, J100
The following illustration shows the routing of the SATA tape drive signal cable.
Important: Make sure that the cables avoid any fan connectors.
Chapter 4. Removing and replacing server components
81