Lenovo ThinkServer RD120 Hardware Maintenance Manual page 140

10. Install the cover (see "Installing the cover" on page 57).
11. Slide the server into the rack.
122
ThinkServer RD120 server Machine Types 6444, 6445, 6446, and 6447: Hardware Maintenance Manual
1
Shuttle assembly
2
Shuttle release latch
1. Align the openings in the sides of the shuttle with the protrusions in the sides
of the server, and lower the shuttle into the server; then, slide the shuttle
toward the front of the server until it clicks into place. Make sure that the
shuttle locking latch holds the shuttle securely in place.
2. Slide the power backplane toward the system board until the connectors mate
(see "Installing the power backplane" on page 105).
3. Install the power supplies (see "Installing a hot-swap power supply" on page
95).
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
4. Reconnect to the system board the cables that you disconnected in step 7 of
"Removing the system board and shuttle" on page 119.
5. Install the VRM and each microprocessor with its matching heat sink (see
"Installing a microprocessor" on page 113).
6. Install the DIMMs (see "Installing a memory module" on page 88).
7. Install the air baffles.
8. Install the riser-card assembly and all adapters.
9. Install the fan-bracket assembly.