Specifying Netware Protocols - Canon imagePROGRAF iPF755 User Manual

4.
Specify the printer type.
1.
To use the printer in queue server mode, choose Other/Unknown in Type. To use remote printer mode, set
Printer Type to Parallel and Position to Manual Load.
2.
Press the Esc key.
3.
After the confirmation message is displayed, choose Yes and press the Enter key.
5.
Set a password.
1.
In Available Options, select Print Servers and press the Enter key.
2.
Select the print server created in step 2 and press the Enter key.
3.
Select Password, and press the Enter key to display the password input dialog box.
4.
Enter the password and press the Enter key.
6.
Press the Esc key several times to display the dialog box for confirming that PCONSOLE is finished.
7.
Click Yes to exit PCONSOLE.

Specifying NetWare Protocols

Follow the steps below to configure NetWare protocol settings other than the frame type by using RemoteUI.
Note
• For details on RemoteUI, see "Using RemoteUI."
1.
Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2.
Select Administrator Mode and click Logon.
3.
If a password has been set on the printer, enter the password.
4.
Click Network in the Device Manager menu at left to display the Network page.
5.
Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.
6.
Make sure the Frame Type indicates the frame type used on the NetWare network.
7.
To use burst mode, choose On for NCP Burst Mode.
Note
• Burst mode supports fast data transfer when printing in queue server mode. Normally, choose On.
iPF755
Network Setting >
→P.759
Network Setting (Windows)
Specifying NetWare Protocols
>
10
775