Canon imagePROGRAF iPF755 User Manual page 741

Inter- Ether- Auto Detect
face net
Setup Driver
Comm.Mode
Ethernet Type
Spanning Tree
MAC Address
Interface Print
Return Defaults
System Sleep Timer
Setup
Buzzer
Contrast Adj.
Date & Date
Time
Time
Date Format
Language
Time Zone
Length Unit
Detect Mismatch
Paper Roll Selection 1
Size
Basis
Roll Selection 2
iPF755
Setting Item
Printer Parts
Description, Instructions
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings
values of Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported
over the LAN.
Indicates the MAC address.
Print interface settings information.
Choose OK to restore Interface Setup settings to the
default values.
Specify the period before the printer enters sleep
mode.
Choose On for the buzzer to sound in case of errors.
Adjust the Display Screen contrast level.
Set the current date.
Set the current time. Available only if the Date set-
ting is specified.
Specify the date format.
Specify the language used on the Display Screen.
Specify the time zone. Time zone options indicate a
main city in this time zone and the difference from
Greenwich Mean Time.
Choose the display unit for length. Change the unit
displayed for the remaining amount of roll paper,
Tot.Print Area, and so on.
Specify printing behavior if the type and size of paper
specified in the printer menu does not match the type
and size in the printer driver.
Choose Pause to have printing paused under these
circumstances. Choose Warning to continue printing
after notification. Choose None to continue printing
without notification. Choose Hold Job to store jobs
with mismatched types and sizes of paper on the
printer hard disk, in a print queue awaiting process-
ing. (See "Using the Printer Hard Disk.")
If roll size detection is activated, choose whether ISO
A3 (297mm) or 300mm Roll is applied when a roll
of an intermediate width is detected.
If roll size detection is activated, choose whether
10in. (254mm) or JIS B4 (257mm) is applied when
a roll of an intermediate width is detected.
> Control Panel >
9
→P.566
725
Menu Settings