HP F2974KT - OmniBook 500 - PIII 700 MHz Manual page 95

7. Release the two latches at the sides of the RAM module by pressing them outward, so
that the free edge of the module pops up.
8. Pull the module out of the connector.
9. Carefully insert the edge of the new RAM module into the connector at about a 30°
angle until it is fully seated. Then press down on both sides until the latches snap
closed.
10. Move the keyboard back into position. Slide its front edge into the computer case,
then lower the top of the keyboard into place.
11. Reinstall the three screws along the top of the keyboard.
12. Hold the plastic panel in your right hand, and insert the tabs on the left end of the
panel into the slots in the computer case just above the ESC and F4 keys.
13. Slide the panel to the left and press it into place.
14. Reinstall the battery.
Configuring and Expanding Your Computer
Installing Additional RAM
Corporate Evaluator's Guide 95