To Undock The Computer - HP F2974KT - OmniBook 500 - PIII 700 MHz Manual

Making Connections
Using an Expansion Base

To undock the computer

1. Important: Close any files that reside on network drives or module drives in the
expansion base.
2. Press the undock switch on the right side of the expansion base.
–or–
Click Start, Eject PC.
You can use the undock switch when the computer is on, off, or in Standby or Hibernate
mode.
When undocking the computer, you may need to wait 10 seconds or more for the
computer to undock—the computer may not respond while it is updating its
configuration.
Using the emergency undock latch
If you cannot undock the computer using the undock switch or the Start menu, use the
emergency undock latch on the right side of the expansion base.
1. If a security cable is attached to the expansion base, remove it.
2. Slide the button down, then move the entire latch forward to undock the computer.
60 Corporate Evaluator's Guide