Connecting The Power Cord; Connecting The Interface Cable - Sharp AL-1000 Series Operation Manual

Connecting the power cord

Ensure that the power switch of the copier is in the OFF position. Insert the removed
1
power cord into the power cord socket at the rear of the copier.

CONNECTING THE INTERFACE CABLE

To use an AL-1000 series machine as a laser printer, connect it to the parallel interface cable.
Use the supplied parallel interface cable.
For specifications of the parallel interface, see page 31.
Check that the power switches of both the printer and the computer are in the OFF
1
position.
Plug the parallel interface cable into the printer interface connector. Fasten the two
2
bail clips at the side of the printer connector to hold the interface connector in place.
Plug the other end of the cable into the parallel interface connector on your computer.
3
(Refer to your computer manual for details.)
The printer sends and receives data bi-directionally and at high speed. Some
switch boxes and pass-through devices cannot support high-speed, bi-
directional transfer of data, and using them may cause printing errors.
INSTALLING THE OPTIONAL PRINTER UPGRADE KIT
Bail clip
Parallel interface connector
Interface connector
Cable
1
9